bottleneck
Choose style:

Author Topic: Z wave secondary/primary support  (Read 4666 times)

0 Members and 1 Guest are viewing this topic.

Offline jamenlang

  • Backer
  • *
  • Posts: 97
  • Thanks: 0
  • Registered : 14/08/2014
    YearsYearsYearsYearsYearsYearsYearsYearsYearsYears
Z wave secondary/primary support
« on: August 14, 2014, 10:25:52 am »
I have an existing z wave controller (2gig go control) for my alarm system, I was hoping to add the almond as a primary controller so I could get sensor information from almond as well as have non alarm z-wave sensors.

I was able to pair the almond to the system but it says unknown device on both the almond and go control panel.
3x Cree connected bulbs - mostly working, some toggle failures using the app; Monoprice PIR - working, waiting for temperature rules;  Trane Thermostat - working; Linear T500Z - working; 3x GE outlets - working; Aeon G2 micro switch, working.

LGNilsson

  • Guest
Re: Z wave secondary/primary support
« Reply #1 on: August 14, 2014, 11:02:44 am »
This is not something that's all that easy to do, as in as much as this is part of the Z-Wave specification, each and every gateway manufacturer has their own unique quirks and ways of doings things.
As such it's quite easy to have a secondary controller from the same manufacturer, but really quite hard to do with a gateway from another company.

 

Page created in 0.044 seconds with 20 queries.