I'm having a similar issue to some other people, but I'm using an AT&T Uverse Router. I didn't want to hijack anyone's thread, which is why I made this one. I am actually replacing a switch with the almond+ while adding some range . I ran through the setup process yesterday, then updated the firmware to the new one that allows AP mode, I seemed to not have any issues yesterday during the setup process. I actually had the A+ connected through the switch yesterday, which in turn connected to the ATT router, but I thought that was a bit redundant since the A+ has ports that can be used. Yesterday, the A+ stayed connected to the internet for quite a while and had no issues using it with multiple different devices. Today, I set it in AP mode and removed the switch from the equation, but have had nothing but problems keeping a connection to the internet. Within a couple of minutes connecting a wireless device and beginning to use it, the connection drops out and will not come back up unless the A+ is restarted. I believe that everything is connected properly so any help would be greatly appreciated.