Aeotec z-wave motion multisensor not working

[Jbeaman]

I found this really cool Aeon Labs Aoetec motion detector with temperature, light, and humidity sensors.  Saddly none of the functionality is working.   The motion status shows always shows MOTION DETECTED and doesn't update its status.

http://www.amazon.com/Aeon-Labs-Aeotec-Z-Wave-Multi-Sensor/dp/B008D5TYGU/r

Of course it would be nice to also get access to the other sensor's features.  It's the only one I've seen on the market to have all these sensors, I really can't wait to get it working and start logging the data and importing into almond+ apps.

[Blueiris8]

Good to know.  I was thinking about purchasing one as well.  Hopefully they add support.

[Talard]

Hey !

I'm really interested in this sensor too. I plan tu buy asap i've got my almond+ but if it's not working at all, i should wait.

Any news on your side ?

[Blueiris8]

Lars, any chance you have one of these in your shop that you are adding support for?  Good price for all the functionality.

[LGNilsson]

We have ordered one, we're just waiting to get the shipment sent over from the US to our office in India.
We'll make it work, but we also need to figure out how to support multi-sensors in a clever way in our UI.

[mrv777]

+1
Just hooked up this sensor last light.  The motion detection does say "Detected" very often, no other functionality yet.
Looking forward to this being supported 

[Vito]

I'm looking forward to this as well.  I have these multi-sensors, as well as a few of the other HomeSeer 3in1 sensors.

[mparadis]

I know some changes were made in the latest firmware version, any chance these are supported now? Thanks!

[LGNilsson]

Motion and temperature should work, but no other features.

[Talard]

For now, Motion is okey for me but no temperature  yet.

[Kalle]

For my sensor the same status
motion is working fine and no view for temperature