Z-Wave USNAP module for Thermostat

[Simonups]

Tested the Z-Wave USNAP module for 3M-50 thermostat and does link with almond+.
Change the setting is instead.

Current have the wifi and z-wave connected to the thermostat and both can control the settings.

You can control the temp but does not update the current temp inside the house. The sliders need to have a value instead a dot or triangle where you see what temp is been set.
The web interface "https://connect.securifi.com/home" or login to router with the IP address and the Display of the router does not update the current temp.
Almond+ , web and display shows 77 degree, but thermostat show 73 degree.

[Simonups]

bump

[LGNilsson]

Is this the RadioThermostat module? As it's the only one we support so far.

[Simonups]

This is a CT50 from Radio Thermostat. I have a Wifi module installed and z-wave module. Wifi works perfect.
The Almond+ will see the readings when you sync to it like add the sensor. Will work for max 10 min then will not work anymore,
You cant change afterwards the settings for the thermostat and will not it show changes when you apply direct on the Thermostat.
Can it be the almond loses it connection on the Thermostat?
How often does it send a life signal to the sensor.