2
Choose style:

Author Topic: GE Link LED light bulbs  (Read 44213 times)

0 Members and 1 Guest are viewing this topic.

Offline SecureComp

  • Backer
  • *
  • Posts: 541
  • Thanks: 1
  • Registered : 05/08/2014
    YearsYearsYearsYearsYearsYearsYearsYearsYearsYears
Re: GE Link LED light bulbs
« Reply #60 on: March 18, 2016, 11:26:04 am »
I have the same problem with sensors: i can not add additional sensors to my 2 existed. Two door sensors are working. Looks like A+ trying to add the sensor but than message pop up: failed. Doors sensors are Z-bee. I have tried to add garage door sensor  also which is Zig-Wave and got the same message. this is software problem, not sensors.

Only time I've experienced this issue is when the timeout kicked in because I was slow initiating the pairing or with a weak signal from the sensor.

When I relocated the sensor closer to the Almond+, I was able to pair.

Make sure you have the pairing process initiated on the sensor prior to searching for it with the Almond.
Make sure the sensor is close enough to the Almond device.
Kickstarter Backer
Securifi Wiki Editor and Beta Tester, Not a Securifi employee
Almond+, many sensors, IOS App, Android Apps and Widgets

Offline Ohiomedic

  • Backer
  • *
  • Posts: 446
  • Thanks: 0
  • Registered : 27/05/2014
    YearsYearsYearsYearsYearsYearsYearsYearsYearsYears
Re: GE Link LED light bulbs
« Reply #61 on: March 18, 2016, 10:07:00 pm »
Only problem I've had with the link bulbs is occasionally I have one or two disassociate themselves. I have to perform the reset to them and repair. I haven't had any problems adding other type sensors either.

 

Page created in 0.069 seconds with 20 queries.