Choose style:

Author Topic: Remotec ZXT-120  (Read 2413 times)

0 Members and 1 Guest are viewing this topic.

Offline freddanster

  • Backer
  • *
  • Posts: 1
  • Thanks: 0
  • Registered : 01/09/2013
Remotec ZXT-120
« on: September 10, 2014, 02:51:39 am »

I'm new to this whole Z-wave thing, and i believe i'm just having this problem because this sensor isn't supported yet.

I've added the ZXT-120 (it's an AC IR extender) to my Almond+.
Everything shows up fine in the interface, only the current temp is in celcius (which i want) while the setting sliders for heat/cooling are in fahrenheit, but that's not my issue hehe.

The manual of the thing says to do this to learn my unit the IR codes from my AC remote:

"Go to configuration setting page on
the gateway [...] and input
parameter number 27 and
parameter value 000 to select the
dedicated AC code number 000
for learning".

I see nowhere where to send parameter values to my unit from the web ui.
As i said i believe it's simply because this sensor is not supported yet, but i want to ask if im missing something obvious since i'm a novice.



Page created in 0.054 seconds with 20 queries.