bottleneck
Choose style:
« previous next »
Pages: [1]   Go Down

Author Topic: Changing DHCP range  (Read 4958 times)

0 Members and 1 Guest are viewing this topic.

Offline fldude

  • Newbie
  • Posts: 2
  • Thanks: 0
    • Registered : 10/01/2015
    YearsYearsYearsYearsYearsYearsYearsYearsYearsYears
Changing DHCP range
« on: January 10, 2015, 05:09:57 pm »
I have changed the default IP address, and would like to change the range to avoid adding all the static assignments manually.  When i go to change the start range from 1 to 50, I get an error
"DHCP end ip should be greater than the start ip".  Clearly it is, as the end ip is still 250.  I tried reversing the order (pretending the web page was wrong) and put int 250, then 50, and I could not connect back to the wireless to configure it without rebooting.  What am I doing wrong?
Logged

Offline eldaria

  • Kickstarter Developer
  • *
  • Posts: 313
  • Thanks: 1
    • Registered : 26/07/2013
    YearsYearsYearsYearsYearsYearsYearsYearsYearsYearsYearsYears
Re: Changing DHCP range
« Reply #1 on: January 10, 2015, 07:28:18 pm »
What firmware are you on?

There is a bug in one of them where someone swapped a > and a < so it is not possible to set it correctly.
Logged

Offline fldude

  • Newbie
  • Posts: 2
  • Thanks: 0
    • Registered : 10/01/2015
    YearsYearsYearsYearsYearsYearsYearsYearsYearsYears
Re: Changing DHCP range
« Reply #2 on: January 29, 2015, 09:17:14 pm »
Where to I find the firmware version?  All I can seem to find is the software version.
Logged

LGNilsson

  • Guest
Re: Changing DHCP range
« Reply #3 on: January 29, 2015, 09:25:47 pm »
Same thing, apologies if that wasn't clear.
« Last Edit: January 29, 2015, 09:53:34 pm by Lars »
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.031 seconds with 17 queries.

bottleneck