Thank you Ashok, I will post the rules I set up once I get home. As a prelude however, the issue came down to the setting of the last part of the rule where I requested that after 180 seconds, the light turn off. Every time I set it up, the 180 seconds would not save. I had to go back in and sort of mess with the rule as I set it to get the 180 seconds to stick. Hard to explain but first, the entering of the 180 seconds is a pain. The rule does not allow for the simple entering of the number 180. I have to click the arrow until it reaches 180, or copy the number 180 from somewhere else and paste it in after I somehow get the block to highlight. Again, hard to explain. If I simply clicked save after that, the 180 would not save. I have to click the arrow up or down to a number higher or lower and then click back to 180, then hit save. After that the 180 saves. Once I got htis all done, the light runs on and then off properly. Without the 180 of course, the switch was being told to turn off right away after the motion turned it on. Perhaps someone can look into this? Again, I will post the rule once I get home and can access my rules. Thanks again.
One more thing, please try to duplicate the other issue where using the A+ UI, the switch will not turn on by clicking "on". I have to use the dimmer bar on the UI to get the light to turn on. Not a big issue as I do not use the UI to turn lights on and off, but just stating it appears to be a glitch.
