Thanks Fillibar.
If I have planned to go slowly adding devices.
First beginning, lights with motion detectors control.
Since I learned the output of the router, I made a pre-order and so far have not followed much the subject and i am catching up..
By the way, if not abused, you could clarify me a question ??
I imagine that I can combine Z-Wave devices with Zigbee devices with Almond + natively.
But, have almond+ ability to communication with some other driver or controler ( RF 433MHZ or similar ) ?
I'm asking because with the hardware / software that I have now I've done some stuff with arduino, and I'm adding communication by RF 433MHZ for use with some type of controller..
thanks in advance
Best regards
Angel.
P.D. sorry for my ingles, is not very good.