I did not find any previous listing for it in the forums or on the wiki:
Linear WADWAZ-1 Door/Window Sensor
Magnetic sensor for Open/Close works..
Tamper switch works.
Easily paired, removed, re-paired as needed.
Screw terminal for external switch, does not work as of R083. This may be related to the Alarm Event signal and value.
According to the instructions the signals/values the sensor provides are:
Alarm Type:
Internal Switch: 0x07
Tamper Switch: 0x07
External Switch: 0x07
Alarm Event:
Internal Switch: 0x02
Tamper Switch: 0x03
External Switch: 0xFE
Alarm Level:
Internal Switch: Close: 0x00: Open: 0xFF
Tamper Switch: 0x0F
External Switch: Close: 0x00: Open: 0xFF
General notes:
Screw terminals are oriented towards the case which means you must remove the board, insert wires and trim a hole in the case then screw the board back in. Would have been easier if they had made two holes accessible to begin with OR oriented it inside so you could bend the wires any which way.