SZ-PIR02 Motion Sensor won't pair with A+

[jnowland]

I was having trouble with my Securifi Motion Sensor turning on a light, which I had a rule written to do.  I removed both the switch and the motion sensor from my A+ and tried re-adding them both.  The light switch paired perfectly however, the PIR02 motion sensor doesn't seem to want to pair.  I followed the instructions, holding the button inside for 1 second, but nothing happens on the A+.  Please advise.  Thank you

[LGNilsson]

You need to reset it first, press and hold the button for 10 seconds and it'll reset, then you can pair it again.

[jnowland]

Thank you Lars.  I will try that when I get home.  F.Y.I, I don't believe the instructions state this.  If I'm not mistaken, it says to hold it down for only 3 seconds.  Neither here nor there, I'll try tonight.  Thanks again

[fillibar]

I just edited the wiki page to add a note about resetting the sensor based on Lars response. There was nothing about it prior.

[crussell12]

So,  I've had a similar issue,  but can't get the sensor to rejoin.   Honestly?   It doesn't seem to want to reset either.   I hold down the join  button for 10 seconds (20 to be safe).. And... Nothing.   No quick green flicker... Nothing.   Kinda disappointed

[Ashok]

@ crussell12,

Check the battery that might be causing the issue.