Yes to bring up the sensor menu again I did the following:
1) remove the sensor from almond+
2)reboot almond+ (probably not required)
3) on the sensor restore to factory settings on the Swann sensor this was hold the pair button untill the led flashed rapidly (about 6 seconds)
4) add the sensor as per normal procedure
5) on the almond+ touchscreen go to connected sensors, select sensor and press the edit sensor, between the remove and done buttons there is now a "Edit Device Type" button.
6) the check box menu lets you select the following;
Door
Motion
Vibration
Gas
Fire
Flood
KeyFob
Warning Device
Basic
Once you make a selection the button will disappear unless you follow the above again.
Only one option can be selected, temperature is not available and I cannot select Door + Motion.