SmartThings Water Leak and Arrival Sensor

[Ashok]

@ d.kiran,

Hi Ashok - The wiki says it is supported and verified by Securifi. Also, I have the PEQ sensors that work perfectly for Temperature and water sensor. The smart things is exactly the same device. Is there a way I can make the almond+ think that it is a PEQ sensor ?

Lastly, I haven't heard back from you on the Arrival Sensor. Is that supported currently? If not, will you be able to add support ?

It was supported fully, however, with the recent update we added support for the generic device, where we are not sure what all a device supports because few devices they don't mention about it, but supports more than one feature and these kind of devices would get added as generic device for which only the LCD is supported and will be taken care through our future firmware updates for the other UI's. We would try to debug the log files and would get back to you with both the updates.

[d.kiran]

As an update for anyone still looking

1. SmartThings Water Sensor - This works with all the UIs, LCD, Mobile App UI and Rules. The only problem was that it did not pop up the device type. I had to change this on the LCD to water sensor and it started working fine.

2. Arrival Sensor - This is currently not supported. I don't know when the support will be added. @Ashok - I have sent the log files for the Arrival Sensor as well. If you need any more information from my side to support this device, let me know.

[mparadis]

d.kiran does the water sensor also report temperature?

[d.kiran]

d.kiran does the water sensor also report temperature?

Hi, I just saw this message. Yes it does report temperature as well.

@Ashok - Any update on whether the arrival sensor will be supported by Almond+? It's currently available for $16 at Crutchfield and could be extremely useful if you guys can support this. 

[mparadis]

Thanks!

[d.kiran]

Bump  @Ashok - Any update on whether the arrival sensor will be supported by Almond+?

[Ashok]

@ d.kiran,

Bump  @Ashok - Any update on whether the arrival sensor will be supported by Almond+?

Let me check, if we could take some assistance from you and then add the support for Arrival sensor would get back to you.

[d.kiran]

@Ashok - Happy to help in any way I can. Let me know how I can help. Thanks

[Ashok]

@ d.kiran,

Thank you, we may have to provide few files, which needs to be uploaded, please check your PM.

[lukeliu]

@ d.kiran,

Let me check, if we could take some assistance from you and then add the support for Arrival sensor would get back to you.

Happen to see this. It seems the arrival sensor has very low power at channel 24 when transmitting beacon request, where Almond+ uses for association and communication. It seems to be arrival sensor's problem. Wish Almond+ can open up the interface to let user choose which channel to use in Zigbee.