I have a Schlage BE469NX lock that was previously enrolled and working with my A+. The batteries died in it and since i noticed it was not updating on the phone apps or the A+ interface. So i decided to try and remove it, then add it again.
I hit remove on the A+ and then put in the programming code + 0 on the lock. The lock flashed green check mark and the A+ no longer shows the lock. I have unsuccessfully tried to enroll it now about 10 times.
The lock flashes the green check mark each time. The Almond pops up a message that it is enrolling the sensor, then a message that it is "still trying" to get sensor data for a few minutes. Then just times out and all messages go away. The lock does not show up in the list of sensors. I go through the remove process and try again. Always same results.
I even took the lock out of the door and set it right in front of the A+ as some have suggested that sensors should be within a few feet during the enrollment process. No luck.
Anyone have any suggestions, or am i doing something incorrectly?
Thanks