bottleneck
Choose style:

Author Topic: DLINK DCH-Z110 Sensor with Almond+ not working  (Read 2277 times)

0 Members and 1 Guest are viewing this topic.

Offline pete82

  • Newbie
  • *
  • Posts: 7
  • Thanks: 0
  • Registered : 27/12/2016
    YearsYearsYearsYearsYearsYears
DLINK DCH-Z110 Sensor with Almond+ not working
« on: January 08, 2017, 05:23:07 pm »
Hello guys,

i bought recently a couple of these sensors

http://www.dlink.com/uk/en/home-solutions/mydlink-home/home-monitors/dch-z110-mydlink-door-window-sensor#
It's a 3 in 1 door sensor (    (1)Door/window, (2)temperature, (3)illumination 3in 1 sensor ))

I tried to add it on my almond+ but unfortunately it failed. There were 3 possibilities to add it:

1. As smoke sensor
2. As multisensor
3. Other
4. Empty

As multisensor it failed completely, there was a message that this sensor is not supported yet
As empty it was identified as door sensor, what is correct but it doesn't show whether a door is open or closed (no reaction)
The other possibilities were also not successful... After some research i figured out, that the sensor should be the same like the Philio PST02-C Door/Window 3 in 1 sensor .
http://www.philio-tech.com/products/PST02-C.pdf

Would it be able to add this sensor in a newer firmware or there are some other possibilities?


Offline pete82

  • Newbie
  • *
  • Posts: 7
  • Thanks: 0
  • Registered : 27/12/2016
    YearsYearsYearsYearsYearsYears
Re: DLINK DCH-Z110 Sensor with Almond+ not working
« Reply #1 on: December 19, 2017, 08:05:27 am »
Any news here?

Tried it with the current firmware and it's still not working :(

 

Page created in 0.043 seconds with 16 queries.

bottleneck