Hello guys,
i bought recently a couple of these sensors
http://www.dlink.com/uk/en/home-solutions/mydlink-home/home-monitors/dch-z110-mydlink-door-window-sensor#It's a 3 in 1 door sensor ( (1)Door/window, (2)temperature, (3)illumination 3in 1 sensor ))
I tried to add it on my almond+ but unfortunately it failed. There were 3 possibilities to add it:
1. As smoke sensor
2. As multisensor
3. Other
4. Empty
As multisensor it failed completely, there was a message that this sensor is not supported yet
As empty it was identified as door sensor, what is correct but it doesn't show whether a door is open or closed (no reaction)
The other possibilities were also not successful... After some research i figured out, that the sensor should be the same like the Philio PST02-C Door/Window 3 in 1 sensor .
http://www.philio-tech.com/products/PST02-C.pdfWould it be able to add this sensor in a newer firmware or there are some other possibilities?
