Wall dimmers available in EUROPE?

[takisot]

Hi guys, do you know any wave or zig bee wall dimmers that can be controlled by Almond and can be bought and operate in EU? I need to control my lighting. Also a garage door motor control would be nice.
Thanks!

[takisot]

Anyone? 

[Mike]

i have a flush-mount zwave dimmer from zwave.me that works with the almond,

they also have switches and blinds-control but I don't know if they work. The scene controller with batteries at least is not supported (yet),...

[takisot]

Thanks Mike.
Can you point out the exact model you bought that works? Also, a direct link to the site you bought it would be nice.
Finally, what exactly is flush-mount? Is it installed underneath the dimmer switch or is it a complete unit which needs to replace the existing wall dimmer?

[Mike]

Its a unit that replaces your existing switch/dimmer.
The model is ZME_05458 (Busch-Jaeger Z-Wave Inbouw Dimmer Z-Wave.ME)
I purchased it here,  but they are commonly available on the web (at least in the netherlands,...)

[takisot]

Perfect, thanks! I will order a couple to test them.

[takisot]

Just to follow up and say that the dimmers work brilliantly!
Thanks Mike for the suggestion!

[ThePoorShadow]

Is there any suggestion (for europe) to something like the Fibaro relay switches ( http://www.amazon.co.uk/Fibaro-FGS-221-Double-Relay-Switch/dp/B0093JR656 ) that are mounted behind the already existent wall switches... (wife doesn't want to have a mix of wall switch designs, so I want to automate the already existing ones)

[takisot]

Hello again.

I am having trouble connecting the Almond+ to the Z-wave dimmers (z-wave.me ZME_05458 )
They used to work fine until one of them died.
I tried to install the replacement by first adding it at almond and then pressing 3 times the button as per the dimmer instructions. It failed, so I removed all sensors from Almond+ hoping that I could do it from scratch for both dimmers.
This time, Almond+ does not seem to find any Z-wave device.
What can I do?

Thanks

[takisot]

Never mind, I found the solution thanks to this very helpful blog post:
https://blog.securifi.com/removing-z-wave-sensorsdevices-from-your-almond?subscribe=success#blog_subscription-2