@neeharika
sorry for my late answer, I was very busy the last weeks.
Unfortunatly the shutters are not working by now.
I have the latest firmware AL3-R015-64MB installed, and also rejoined the Devices.
These are the Devices:
SCM-1ZBS : Zigbee Shutter
SCM-1ZW : Z-Wave Shutter
I can set actions like on , off and percentage at the Almond directly but not on the App or Web applet , then they open or shut, but I cannot see the current status or set up any rules.
I have a support ticket running about it until some days, # 331258
Here are my experiences with the other Devices:
PRD2-ZBS (Zigbee Dimmer) - Working 100% fine
PRS2-ZBS (Zigbee Power Switch) - Working 100% fine
PRS2-ZW (Z-Wave Power Switch) - Working 100% fine
PSM-DIN2-ZBS (Zigbee Fuse device) not installed by now
IRP-9ZBS (Zigbee IR-Sensor) - is recognized as Motion Sensor but only shows "Bewegung erkannt" (motion detected) but does not go into "Keine Bewegung" (no motion) , even after hours without any movement in this room. I have also a Zipato Multisensor with the same problem.