no complete boot

[paolosutter]

I have an almond that was 12 months unplugged. Now it starts up with the Almond Logo then the securifi logo comes up and stays 2-3 minutes.
Then the facory test for touch screen comes up and tells "touch the lcd". I then have a line of 00:00:00:00:00:02. stays 2minutes and then the test shows up to touch three squares.
DOne that i have the test passed on a green screen and again i have numbers. This time 3 lines with same 00, 1st line ending with 00, 2nd 02 and 3rd with 03.
That's it.
And it stays there for ever. Any hint?
Thanks.
Paolo

[fillibar]

Did you try doing a reset?

[paolosutter]

Filibar, ciao
Yes i did many times. and i also dd what the support guy told me to unplug it over night. same Issue. It just stops after the touch screen test.

[fillibar]

That is unfortunate. I thought you probably would have tried resetting but figured I should ask. If you already are working with support then I think they will provide more information.

[Shazster]

Try a full 30-30-30 reset? Give that procedure a try.

https://www.router-reset.com/en/30-30-30-reset-factory-defaults-wireless-router/

[belkinrouterlogin]

No complete boot - you have to reset the router and again login to router .

For More Help and support for Belkin router login click here.

[Trunganh1131]

I did quite a lot of times, and I also tried when I said support, unplug overnight. However the problem is only solved on hard screens