bottleneck
Choose style:

Author Topic: Almond+ Not Booting, Black Screen, No More Boot Devices - STOP!  (Read 552 times)

0 Members and 1 Guest are viewing this topic.

Offline hsilva3

  • Newbie
  • Posts: 4
  • Thanks: 0
  • Registered : 01/01/2015
    YearsYearsYearsYears
Almond+ Not Booting, Black Screen, No More Boot Devices - STOP!
« on: February 05, 2018, 06:14:01 pm »
I was getting the Securifi, black dots/bars boot loop previously and then I tried to recover via serial port, by starting the HTTP Server and then upgrading the firmware that way. During that process I got a lot of MTD ERASE FAILURE -22 errors and then after that the unit does not boot up at all.  LEDs on the network ports flash and the readout from the serial port is as follows:

Copyright 2011 Cortina Systems - Golden Gate
JTAG ID: 0x101083e5
CPU Speed : 750 MHz
CPU PLL(0): Locked
Core PLL(1): Locked
Peripheral PLL(2): Locked
DDR PLL(3): UnLocked
Flash Type : F:5 S:0 Width : 0 Size : 2 Pin: 0
BOOT: NAND
BOOT: No More Boot Devices - STOP!




At this point I would like to know how I can proceed from here?  Is there a way to get the unit to boot from USB drive temporarily so that I can rewrite the necessary information to NAND?

 

Page created in 0.05 seconds with 21 queries.

bottleneck