Choose style:

Author Topic: Fibaro Motion Sensor  (Read 2896 times)

0 Members and 1 Guest are viewing this topic.

Offline trickyrick

  • Newbie
  • Posts: 2
  • Thanks: 0
  • Registered : 16/09/2017
    YearsYearsYearsYearsYearsYearsYears
Fibaro Motion Sensor
« on: September 16, 2017, 11:43:22 am »
Hi Guys
My sensor was off line (Smartthings) so I force excluded it in the app.  I cant add it again
What did I screw up
Thanks
Rick

Offline fillibar

  • Backer
  • *
  • Posts: 2060
  • Thanks: 4
  • Registered : 02/08/2013
    YearsYearsYearsYearsYearsYearsYearsYearsYearsYearsYears
Re: Fibaro Motion Sensor
« Reply #1 on: September 17, 2017, 09:10:01 am »
Couple things to try, because it sounds like the sensor still thinks it is paired with the controller:
  • Try to Remove it using the Almond LCD. Even though it is not paired some sensors/devices will recognize the remove command anyways and you should see an unknown sensor removed message at the LCD.
  • Reset the sensor to factory defaults. According to Google that would take:
  • Make sure the Sensor is powered.
  • Press and hold the B-button.
  • Wait for 4-6 seconds for the visual LED indicator to glow yellow (2nd position of the MENU)
  • Release the B-button.
  • Click the B-button, once.
  • Successful reset will be confirmed with the visual indicator changing colour to red and fading.
Almond 3 mesh handling the home.

Offline trickyrick

  • Newbie
  • Posts: 2
  • Thanks: 0
  • Registered : 16/09/2017
    YearsYearsYearsYearsYearsYearsYears
Re: Fibaro Motion Sensor
« Reply #2 on: September 18, 2017, 11:05:31 am »
Thanks that worked.
I still have a problem.  I have add it back to ST and for the first few times it senses motion and reports to ST but after that it stops.  Is there any way to figure out if its the actual sensor or ST
Rick

Offline fillibar

  • Backer
  • *
  • Posts: 2060
  • Thanks: 4
  • Registered : 02/08/2013
    YearsYearsYearsYearsYearsYearsYearsYearsYearsYearsYears
Re: Fibaro Motion Sensor
« Reply #3 on: September 19, 2017, 07:39:19 am »
I do not have ST, so that might be better asked in their forums.
Almond 3 mesh handling the home.

 

Page created in 0.062 seconds with 17 queries.

bottleneck