Smartthings MultiSensor $20

[mparadis]

https://www.amazon.com/dp/B0118RQW3W/

[engr.jpc]

I am thinking to get one for my garage door because my current one from monoprice is no longer working. Does this work well with A3?

[mparadis]

Hmmm, I'd have to check but as far as I remember. I had tested it but then installed it on my Almond+ since that was my primary automation system. I have switched a few things over but none of my sensors.

[bear9rpp]

Would like to know as well.  I have the Almond 2015 and have been looking for a decent temperature sensor. 

[Kinggovernator]

If I remember right it pairs with the A3 as a binary switch. On and or off when opened and or closed. That's all it did this was a while back when I tried one idk if they maybe worked on support for it any or not!?

[mparadis]

Added one last night, showed up as a door/window open / close sensor with temperature. I didn't check to see if it could be changed to another type of sensor. Full disclosure, I have had this one for a little while so I don't know which generation it was because I forgot to check.

[Kinggovernator]

I tried pairing mine again, to my A3 and it comes up as warning device, keyfob, a blank option and something else. The last one is the only one that works but again it acts as only a bionary switch that's it. Idk what model mine is either I know I bought it shortly after the A3 came out. Only used it for a short time bc I replaced it w a visonic one that works well. I paired it by opening and closing it idk if that's how u paired yours?

[mparadis]

I do not recommend pairing while triggering unless specifically told to do so or it won't pair any other way. I did not do so when I paired this one.

[Kinggovernator]

Paired mine like u said, without triggering it and it comes up the same, acting as a bionary switch. Options of warning device, key fob, blank space and something else....
M/N sts mlt 250 I think that's the model number idk if yours is different ?