Hi All,
I have purchased the Almond+ unit as it was released this month in the UK.
I have successfully, configured it for Zigbee sensors however utilising a Fibaro Flood Sensor I can connect it successfully to the hub but it does not allow any interaction, if its wet the sensor audible alarm sounds but there is no change to the hub and it states it is still 'OK'
Realising there is a difference in ZWave protocol in the US to Europe is it that the UK version of the hub incorporates the US ZWave signal which would be why the sensor is not behaving correctly?
Any help would be appreciated,
thanks all and Merry Christmas