Choose style:

Author Topic: Delay in z-wave response  (Read 2287 times)

0 Members and 1 Guest are viewing this topic.

Offline Advanced

  • Newbie
  • Posts: 2
  • Thanks: 0
  • Registered : 04/02/2018
Delay in z-wave response
« on: February 05, 2018, 06:32:34 am »
Super delay in z-wave response can reach 30-40 sec to open or close actuator and 5-6 sec to show that motion sensor detected or not after the action

we are using Fibaro Motion sensor QTY 4 , Fibaro Wall Plug QTY 1, Fibaro Double relay QTY 1

we are facing a huge delay from pressing on/off from Web UI or Mobile to Switch Plug actually very slow response

we did make rule that if motion detected and in away mode switch on the double relay but there is a delay that is not accepted at all

pls advise back ASAP

Offline lucasrangit

  • Newbie
  • ***
  • Posts: 30
  • Thanks: 0
  • Registered : 28/02/2015
Re: Delay in z-wave response
« Reply #1 on: March 09, 2018, 05:41:47 pm »
I have recently noticed this as well. Even before I updated from AP2-R092 to R093. The motion sensor LED blinks quickly for a few seconds. I believe this means it is communicating.


Page created in 0.064 seconds with 21 queries.