bottleneck
Home
Help
Login
Register
Choose style:
Securifi Community Forum
General Category
Ideas/Feature requests
A way to set Z-wave device parameters from Almond+
« previous
next »
Print
Pages: [
1
]
Go Down
Author
Topic: A way to set Z-wave device parameters from Almond+ (Read 8888 times)
0 Members and 1 Guest are viewing this topic.
sfalc
Backer
Posts: 167
Thanks: 0
Registered : 11/09/2014
A way to set Z-wave device parameters from Almond+
«
on:
March 26, 2015, 12:51:36 pm »
Per subject. It would be a very useful feature, quite a lot of Z-wave devices utilises settable parameters.
Initially this could be from the shell over SSH.
Logged
Almond+ with 2 dimmer switches, 2 binary on/off switches, 1 Qubino Flush dimmer, 1 Aeontec micro dimmer, 1 Fibaro Dimmer 2, 1 Lightify RGBW bulb, 2 Lightify Flex RGBW Led strip, 1 WeMo Bulb, 1 Fibaro magnetic door sensor, Vision PIR & temperature sensor.
lucasrangit
Newbie
Posts: 31
Thanks: 0
Registered : 28/02/2015
Re: A way to set Z-wave device parameters from Almond+
«
Reply #1 on:
March 09, 2018, 05:18:35 pm »
This can be done via the LCD UI now.
However, it would be nice to support listing the known parameters and current values. Also, when the set fails, it doesn't give very much to debug with. Is there a log I could send?
«
Last Edit: August 09, 2018, 11:30:07 am by lucasrangit
»
Logged
Print
Pages: [
1
]
Go Up
« previous
next »
Securifi Community Forum
General Category
Ideas/Feature requests
A way to set Z-wave device parameters from Almond+
Page created in 0.04 seconds with 18 queries.
bottleneck