Securifi Community Forum
Apps => Android app => Topic started by: hashish on February 22, 2015, 07:05:53 pm
-
So I just got some GE Link bubs, and I set one up on the router (had to manually reset the bulb before working) and I can turn off/on/dim via web interface and directly from router, but it is not showing up on the app.
-
Did you sync the router with your account and then sign into the app with same account?
-
Also make sure you have the correct router chosen in the app.
-
So I just got some GE Link bubs, and I set one up on the router (had to manually reset the bulb before working) and I can turn off/on/dim via web interface and directly from router, but it is not showing up on the app.
Is it IOS app or Android App?
-
Using the IOS app, I have seen the same thing when I last reset my A+ after adding an unsupported sensor. Suddenly, I could not see any sensors on the IOS app. In order to recover, I tried the following:
1. Rebooted the A+ (no help)
2. Followed the procedure to remove "ghost" sensors (no help)
3. Ran diagnostics (no help).
4. Removed one of the sensors that was working, re-added it.
a. At this point, all my sensors showed up on the app but were unresponsive, with none of the usual controls.
b. I toggled the sensors from the A+ and they fixed themselves as I toggled each one. For the motion sensors, I triggered it and it was fixed.
After I "recovered", I have added more sensors and switches without issue. I have also rebooted without issue. I have no idea what happened, but it was weird.