Securifi Community Forum
Securifi Products => Almond+ => Topic started by: msorelle on August 20, 2014, 07:17:52 pm
-
I had an issue with autoneg on the wan port only, both lan1 and wan0 were connected to the same switch with the same commercially manufactured 1M cat 6 patch cable and the wan port was flapping, when I set it to 100M/FD on the switch the wan port was stable.
On a couple of unmanaged D-Link switches, I had no problems, so not really sure if there might be an autonegotiation issue there but thought I should mentioned it.
This is the first product I've had this issue with on this switch
I'm not doing much more testing at this point as I've moved to AP only mode until the firmware gets a little more mature