Securifi Community Forum
Securifi Products => Almond+ => Topic started by: flyingvette on April 13, 2015, 09:49:36 pm
-
Anyone else had this issue? Basically lost all functionality on devices. Is there a way to refresh / reload that part of the interface without having to re-add all devices? Hoping to avoid having to physically re-add them all.
-
Even if you reset the router by holding the reset button for 10 seconds you won't loose the devices or rules. All the other router settings will be reset though. I have had to do this before.
-
Maybe I will try that 10 sec. hard reset. I have been just dealing with A+ not reading the proper state of 1/2 my lights, simply because they are such a PIA to reset. I have been putting off going around and collecting them all, resetting each one then re-adding it. The nice weather is finally here and I have too much to do outside to spend an afternoon arguing with light bulbs that don't want to reset.
-
I'll give that a shot when I can write down all my network settings.
Every time I flash a new update now I also get huge amounts of 'resolving host' errors on my hardwired pcs. Also annoying.
-
So the reset ended up working.... up until I went to go change the timezone via openWRT. Nuked all the sensors again.
Ugh. Ugh.
-
Can you please go to Help, Send Logs in the LCD UI and send us logs when this is happening so we can look into what's going on, as this is clearly not normal behaviour and it's not something we've come across.
-
Ok, log sent.
-
I realized last night that the rules can still access the sensors. I can't use the webUI to switch on or off or monitor any of the sensors. But the rule setup on a timer works on the light it's attached to. But only since I reverted the timezone back to default in openwrt.