Securifi Community Forum

Securifi Products => Almond+ => Topic started by: SrOC on August 16, 2014, 01:36:15 pm

Title: Unable to upgrade to new firmware
Post by: SrOC on August 16, 2014, 01:36:15 pm
I'm trying to upgrade the firmware to R065 but I'm having issues when trying to flash it. On IE9+ "cancel and proceed" buttons does not appear:

(https://dl.dropboxusercontent.com/u/20876649/ie_error.JPG)

On Chrome it shows this error:
This page contains the following errors:
error on line 136 at column 33: Attribute style redefined
Below is a rendering of the page up to the first error.


(https://dl.dropboxusercontent.com/u/20876649/chrome_error.JPG)
Title: Re: Unable to upgrade to new firmware
Post by: pete on August 16, 2014, 03:11:11 pm
Welcome to the forum SrOC.

Thank-you for bringing the issue up. 

The firmware upgrade pages should work with whatever browser.  That said here still do utilize IE but mostly its been Firefox/Chrome/Opera.

For the backup and upgrades; and this is me.  I have been using the OpenWRT pages.  Give it a try with Firefox / Chrome and see if that works for you.

Note too this past week there have been some routing table stuff relating to the internet in general causing some spotty outages.  (IE Ebay was down for a time in the UK).  Here in the midwest I couldn't get to some web sites.  These issues could cause partial corruption of downloaded files.  The blame it is said related to some updating by Verizon here in the US; well like we are hitting the limits globally of what the internet routers can actually handle these days.  Thinking now the issues have cleared up a bit. 



Title: Re: Unable to upgrade to new firmware
Post by: SrOC on August 16, 2014, 05:16:53 pm
I just tried with FireFox and I get this:

(https://dl.dropboxusercontent.com/u/20876649/firefox_error.JPG)

BTW... I also redownloaded the file with no luck.
Title: Re: Unable to upgrade to new firmware
Post by: LGNilsson on August 16, 2014, 09:58:06 pm
Please go to System, General Settings in OpenWRT and change back to Cortina under language and styles, design, otherwise the web UI will have the issues you're seeing.
The OpenWRT design doesn't work properly and you'll only have issues if you use it.
Title: Re: Unable to upgrade to new firmware
Post by: SrOC on August 16, 2014, 11:50:24 pm
Changing back to Cortina did the trick! Thx!!!