Securifi Community Forum

Securifi Products => Almond+ => Topic started by: subhunter on February 16, 2015, 12:27:16 pm

Title: 5ghz not working when using range extender
Post by: subhunter on February 16, 2015, 12:27:16 pm

when using range extender mode my 5ghz is not transmitting.  I can get it to work if I setup the almond+ as a router.  then both 2.5 and 5 are transmitting,  I have tried a hardware reset same result also tried re flashing same problem is there a link with old firmware so I can install the previous version?

update: I was able to find the previous version of software I had (AP2-R069-L009-W016-ZW016-ZB005) and re-installed that and all is working again

Title: Re: 5ghz not working when using range extender
Post by: jmschnur on February 16, 2015, 03:41:27 pm

Works for me. 5ghz to 5 ghz only.

Title: Re: 5ghz not working when using range extender
Post by: subhunter on February 18, 2015, 05:31:56 pm

Using insider home you can see the 5ghz transmit temporarily then back off

Title: Re: 5ghz not working when using range extender
Post by: Amritendu on February 19, 2015, 08:08:17 pm

Wireless is not completely optimized, however rare with the R070 firmware. So was this happening with R070?

Title: Re: 5ghz not working when using range extender
Post by: subhunter on February 25, 2015, 02:19:23 pm

Yes it was I used inSSider program and could see the 5ghz transmit or come on for a brief second then back off, the 2.4ghz worked OK, rolled back to the previous firmware and could see the 5ghz signal holding fine

Title: Re: 5ghz not working when using range extender
Post by: Amritendu on February 26, 2015, 09:55:05 pm

This is already brought to the notice of developers. Expecting full optimised Wi-Fi soon enough.

Title: Re: 5ghz not working when using range extender
Post by: mparadis on February 28, 2015, 09:28:32 am

subhunter were you connecting to the guest account at all? This was reported elsewhere I believe that connecting the guest account then disconnecting was causing the network to drop out. I don't know if this is a wide spread / repeatable issue or if a fix is the works.

Title: Re: 5ghz not working when using range extender
Post by: subhunter on March 02, 2015, 12:27:03 pm

No I do not use a guest network