Securifi Community Forum
Securifi Products => Almond 3 => Topic started by: kcb4 on November 28, 2016, 11:45:01 am
-
Where can I get z-wave adaptor for the Almond 3?
-
@ kcb4,
You could place the order via Amazon at https://www.amazon.com/Securifi-Z-Wave-USB-dongle-Compatible/dp/B01LAX97K4/ref=sr_1_1?ie=UTF8&qid=1480356019&sr=8-1-spons&keywords=securifi+dongle&psc=1
-
Thank you. Have the dongle, but cannot figure out what to do next. Plugged dongle into my Almond 3 and nothing. Plugged it into my Surface 3 (windows 10) and nothing. Looked and the instructions and noticed the software download link (visionsecurity.com/tw . . etc.), but that link doesn't work. Even then, I'm not understanding how to make z-wave work with my Almond 3 if I have to plug the USB into my computer??? Help!?!?!
Thank you,
-
@ kcb4,
Thank you. Have the dongle, but cannot figure out what to do next. Plugged dongle into my Almond 3 and nothing. Plugged it into my Surface 3 (windows 10) and nothing. Looked and the instructions and noticed the software download link (visionsecurity.com/tw . . etc.), but that link doesn't work. Even then, I'm not understanding how to make z-wave work with my Almond 3 if I have to plug the USB into my computer??? Help!?!?!
Thank you,
Once you plug in the Z-wave dongle, ensure that the light is red on the dongle, go to Add sensor there we would see a small message saying Z-wave dongle via USB. After this, you can just tap on Add sensor and start adding the Z-wave sensors.
Note: Please note, if the Z-wave sensors are adding to some other network then first follow the removal process before adding.
-
The dongle is meant for the Almond 3 itself, not a computer in this case. You can try to get it recognized on the Almond 3 again:
As for trying again, the overkill method would be:
1) Unplug fob.
2) Reboot router.
3) Wait at least a full minute after it has finished booting.
4) Insert the fob.
5) Wait at least a minute after the fob LED(s) have become active.
6) Check the Add Sensor screen on the LCD for the "Z-Wave via USB" message at the bottom. This means it is recognized and working.
-
Hello. I am migrating my existing z-wave network over to the almond 3 and am wondering if I can just plug in my usb z-wave dongle (gen5 aeotec) and the devices will show up? Where can I check to make sure that the almond actually sees the usb stick? Also, do I need to add z-wave devices via the almond only, or can it be done using the android app also? Thanks
-
No, devices will not migrate. Due to the unique IDs and security involved you cannot copy or "backup" Z-Wave devices (or ZigBee for that matter). Not even Securifi's "fault" it is the standards themselves.
As for checking status, on the LCD in the Add Devices, you should see a message at the bottom of the window like "Z-Wave via USB" once it is plugged in.
They can be added via the app also, while in local connection mode. A + icon will be at the top right of the devices screen then.