Securifi Community Forum
Sensors and Home Automation => Home automation => Topic started by: obmd1 on July 12, 2015, 09:28:04 pm
-
Z wave should be a mesh network, right? Do we know for sure the almond + supports it? I have sensors which I now know for sure rebroadcast (lutron in wall switches) and that work fine. I have a motion sensor that I want to put essentially next to one of these wall switches, and it loses connection when it is moved too far away from the Almond +. So do we know the almond can run a mesh network? Do we know the Aeon multi sensor can "see" the almond + through the mesh network and not "need" to be connected directly to it?
An has anyone had experience with increasing the range of these individual sensors?
-
As far as I'm aware, only the grid connected zwave devices rebroadcast.
-
Like light switches? The sensor I am trying to use is right over the switch and loses connection.
-
Yes, light switches should rebroadcast.
As far as I know, this is not linked to your controller, all grid-powered devices should do it when they are included in the same network (ie. have the same network id)
-
It's not supporting the sensor. Does anyone have experience making this work?
-
Aeon has gotten back to me that I need to "heal" the network when it is making the connection through rebroadcast. Do we have a means through which the Zwave mesh network can be optimzed, re-built, etc?
-
Fixed this. Bought Smart Things. Works flawlessly.