Securifi Community Forum

Securifi Products => Almond+ => Topic started by: jasonl99 on August 20, 2014, 12:25:31 pm

Title: Minor display bug in Access Point Mode
Post by: jasonl99 on August 20, 2014, 12:25:31 pm

I noticed a bug in the web console.  I am using my Almond+ as an access point.  One the main page, the "network" card shows

IP: 192.168.1.3
DHCP Client: 1

If I click that card, it shows

a "LAN Settings" section with
IPv4 Address: 10.10.10.254


Also, it shows the DHCP Server.  This should not be active if the Almond+ is in Access Point mode.

Incidentally, the Almond+'s ip address is actually 192.168.1.151 at this point.  So none of the displays is accurate.  I had set the address manually at one point trying to get it set up so I could update the firmware to the one that can do access point mode.

Title: Re: Minor display bug in Access Point Mode
Post by: LGNilsson on August 21, 2014, 03:16:33 am

Thanks for the heads up, I'll pass this on to the software team.