Securifi Community Forum
Sensors and Home Automation => Home automation => Topic started by: Hoju on December 16, 2015, 04:19:30 pm
-
Hello,
Lock is working great with Almond+ but through the app or web if I want to add a PIN code the Almond+ says it needs to be 5-8 numbers but the instructions for the lock and using the keypad 4 digits works. Anyway to get this working in next update? I am on R83.
-
I think mine always required more than 4 (even using the keypad to set up). I would use as many as you can remember.
-
@ Hoju,
Could you please confirm which module you are using the on the lock, is it Z-wave or Zigbee because Z-wave we added support for the user pin which works through Web UI and App. However, if it is Zigbee then we have not implemented that feature yet.
-
The Kwikset 910TRL is ZWave. Using one on an installation. (haven't updated the firmware for them yet, can't report an updated status. :(
http://www.kwikset.com/products/details/electronic-locks/910trl-zw-l03-smt.aspx?productseo=910trl-zw-l03-smt
-
I was able to do a 4 digit pin code just now through my app (android) without issue. But can't figure out how to delete the new pin :P
-
@ mparadis,
Tap on the 4 digit pin code again and that should allow you to delete the pin.
-
Thanks Ashok!