Securifi Community Forum

Securifi Products => Peanut plug => Topic started by: splitice on May 24, 2018, 12:34:45 am

Title: Plugs don't reset
Post by: splitice on May 24, 2018, 12:34:45 am
Hi,

We are currently doing R&D with a set of the original Walnut plugs acquired through a local rebrand. They seem to work decently, however refuse to be reset.

We have tried:

None trigger a reset. Beacon requests are sent, and NwkOpen replies received however the plugs never join, indicating that they are still fixated on their old hub.

These devices identify as:
appVersion: 18
hwVersion: 17
manufacturerName: "Sercomm Corp."
modelId: "SZ-ESW01-AU"
stackVersion: 80
swBuildId: ""

Instructions? Is there a firmware update or similar to rectify this issue?
Title: Re: Plugs don't reset
Post by: mparadis on September 17, 2018, 07:38:00 am
Usually anything rebranded would be set with its own software version so you'd need to check with the company selling those devices. Also, Peanut firmware is only available directly through an almond router.