Securifi Community Forum

General Category => Ideas/Feature requests => Topic started by: sfalc on March 26, 2015, 12:51:36 pm

Title: A way to set Z-wave device parameters from Almond+
Post by: sfalc on March 26, 2015, 12:51:36 pm
Per subject. It would be a very useful feature, quite a lot of Z-wave devices utilises settable parameters.
Initially this could be from the shell over SSH.
Title: Re: A way to set Z-wave device parameters from Almond+
Post by: lucasrangit on March 09, 2018, 05:18:35 pm
This can be done via the LCD UI now.

However, it would be nice to support listing the known parameters and current values. Also, when the set fails, it doesn't give very much to debug with. Is there a log I could send?