Securifi Community Forum
Securifi Products => Almond+ => Topic started by: AlexK on November 15, 2014, 06:59:52 am
-
Updated to R069 and tried to reconnect a Fibaro wall plug , but it didn't work.
Almond+ recognizes the plug, but fails to establish a connection.
The wall plug is on the supported devices list and worked before (another one is still connected).
Is this a known issue and is there a workaround?
-
Did you reset the plug first, before trying to add it again?
Go to Add Sensor, tap Remove, press the button on the Fibaro plug three times quickly (this can be a bit quirky due to the delay of the relay) and you should see a message about an unknown sensor being removed.
Now you can add it back again.