Securifi Community Forum
Sensors and Home Automation => Where can I buy sensors? => Topic started by: grouter on December 17, 2016, 03:20:16 pm
-
Motion, temp, humidity and light
$22.99 and free shipping
Not sure if this is supported yet. Anyone using this?
http://www.monoprice.com/mobile/product/description/15902?maincategoryid=122&categoryid=12212&subcategoryid=1091804
-
Looks EXACTLY like the ZOOZ Multi-Sensor I just got and that works fine. The manual is a bit different, but has all the EXACT same values and settings...
Ordered... Will let people know. Too bad I paid more for the ZOOZ.
-
Looks EXACTLY like the ZOOZ Multi-Sensor I just got and that works fine. The manual is a bit different, but has all the EXACT same values and settings...
Ordered... Will let people know. Too bad I paid more for the ZOOZ.
I received two today and can't pair either of them. Any luck?
The included book says powering on an unpaired unit will blink 5 times, once if already paired. Mine cycle through some colors, but i don't believe 5 times. A single button press after that gives one blink and never shows as detected on the LCD.
Any idea how to reset?
-
Have not gotten mine so not sure yet. If they WERE ZOOZ-based, pressing the button twice is supposed to start pairing. It it does not happen, it says press it quickly "several times" to make sure it goes through.
You can also try doing a remove just to make sure it is "cleaned" from the Almond before adding it again.
-
Have not gotten mine so not sure yet. If they WERE ZOOZ-based, pressing the button twice is supposed to start pairing. It it does not happen, it says press it quickly "several times" to make sure it goes through.
You can also try doing a remove just to make sure it is "cleaned" from the Almond before adding it again.
I tried this and more. No luck...
-
Bummer. Well, I will have one soon. See if mine has any better luck I guess.
-
Success!
Turns out I was pressing the tamper detection button inside the unit. The "program switch" is in a pinhole on the outside. Once pressing this the LED flashed 5 times as noted in the manual and pressing 1 time again started the pairing process.
The Zooz manual has the correct information and the Monoprice one does not.
I'll attribute at least half of this USER ERROR to Monoprice's lacking documentation ;)
-
Initial testing shows that these units are far more responsive and accurate with light level (lux) detection than the Aeon Multi6. And maybe a bit more sensitive with motion detection as well.