Securifi Community Forum
Securifi Products => Almond+ => Topic started by: dbuttke on July 12, 2014, 04:57:24 pm
-
We have a teleworker here whose cisco equipment has been connecting for many many years through many different routers.
Won't seem to work through the almond + however.
Anything special I need to do on the AP?
EDIT-------------------------------
To update and add a bit of info I have found this thread:
http://forum.securifi.com/index.php/topic,1135.0.html
And tried OpenWRT -> Services -> ALG -> IPSec -> uncheck to disable
No success. Cisco 800 series still offline.
I went to the Openwrt wiki:
http://wiki.openwrt.org/doc/uci/firewall#ipsec.passthrough
Added all 3 of those under the Custom Rules section and restarted the firewall and no success
I tried forwarding ports 50, 51, 500 and 4500 to no success.
I did a factory reset because I found another thread where someone changed the IP range of his network to 192.x.x.x and port forwarding didn't work.
I had done the same. Back to bone stock and redid all of the above. No success.
-
Just to get a clear picture, is this what you are trying to do?
Computer -> Cisco VPN device -> Almond+ -> VPN Server
-
Can you please try the same thing after loading "cs75xx_spacc.ko" ?
please do the following
1. Get the terminal access and type the following command below
insmod /lib/modules/2.6.36/cs75xx_spacc.ko
-
Yes the network is Computer > Cisco 800 series > Almond + > Cable modem
I connected via SSH and tried to run that insmod /lib/modules/2.6.36/cs75xx_spacc.ko
Was told Can't Insert. File exists.
-
i will get back to you on this. thanks