Securifi Community Forum

Securifi Products => Almond+ => Topic started by: lmmmmm on August 29, 2015, 01:59:53 pm

Title: How to clear a Motion Detector status
Post by: lmmmmm on August 29, 2015, 01:59:53 pm

I have a PEQ Motion Detector.

How do I clear the sensor status in the app or A+ once a motion has been detected.

Also, notification is only in the logs, not in the main notification area.

Title: Re: How to clear a Motion Detector status
Post by: Ashok on August 31, 2015, 01:24:32 am

@ Immmmm,

I believe the sensor changes automatically after 10 seconds if no motion is detected.

Title: Re: How to clear a Motion Detector status
Post by: lmmmmm on August 31, 2015, 03:07:44 pm

hmmm. well the status has never changed via the App, or A+...

Anyone else have this issues with PEQ?

Title: Re: How to clear a Motion Detector status
Post by: grouter on September 03, 2015, 02:22:58 am

No issues here with the motion sensors. I had one of the PEQ, water sensors get stuck in the "flooded"state and I reseated the battery to fix it.

Title: Re: How to clear a Motion Detector status
Post by: lmmmmm on September 05, 2015, 01:41:15 pm

I did a reset and readded the sensor and now it works.