Securifi Community Forum

Sensors and Home Automation => Home automation => Topic started by: Vinzz on August 30, 2014, 02:07:58 pm

Title: zwave.me (EU): Will it work?
Post by: Vinzz on August 30, 2014, 02:07:58 pm

Hello,

I'm planning on buying serveral z-wave switches (slaves) from zwave.me (http://www.zwave.me/index.php?id=30). but will they work with the Almond+?
i will buy one switch for testing. If it works, i'll will buy a lot more of them and i will post the results here.

Greetz
Vinzz

Title: Re: zwave.me (EU): Will it work?
Post by: LGNilsson on August 31, 2014, 05:40:01 am

It's not a product we've tested, so I can't guarantee it'll work.

Title: Re: zwave.me (EU): Will it work?
Post by: Mike on September 20, 2014, 02:31:32 am

I can confirm the dimmer switch is working,  :D
had to take the mains off, after reconnecting power, just put the almond in add sensor mode and tripple press one of the switch buttons.
Will check the wall controller soon, when i find some batteries for it.

Title: Re: zwave.me (EU): Will it work?
Post by: Mike on September 23, 2014, 01:14:36 pm

the wall controller pairs with the almond but is listed as unknown device,
i get a screen to get and set values but I can not get any actual value,...

how can i provide you with info to get this working?

The previously mentioned dimmer can control the connected light but does not update when the dimmer/switch itself is operated. Is this a limitation or a sign that the device is not fully supported?

Title: Re: zwave.me (EU): Will it work?
Post by: LGNilsson on September 23, 2014, 11:16:04 pm

I honestly have no idea and there seem to be less than zero info on their website about their sensors, so I honestly have no idea.
All the issues are mostly likely because we haven't 1. tested the devices 2. added any kind of support for them and 3. some of them might be using as yet unsupported device classes.

Title: Re: zwave.me (EU): Will it work?
Post by: Mike on September 24, 2014, 02:16:26 pm

this page, towards the end, at least mentions the supported command classes,...
http://manuals.zwaveeurope.com/make.php?lang=en&type=&sku=ZME_05460

without automation in place yet, a scene controller isn't of much use and its a considerably more complex device then a regular binary/dimmer switch,... but I hope support can be added somewhere in the future.