Securifi Community Forum
Sensors and Home Automation => Home automation => Topic started by: igoris on May 01, 2015, 06:03:23 pm
-
Hello,
just to let everybody know.
I recently connected Fibaro Roller shutter v2 to Almond + (R072). It was recognized as roller shutter, and let me operate my curtains from touchscreen gui. The problem was it is not supported via web interface or via IOS app. I then tried to re add them and this time I added them as multiswich. Adding them as multiswitch gave me a dimmable switch option in web, app and on A+ itself. It is working now, I can open and close my curtains ok. Then I have created rules to open it in the morning and close in the evening. Evening rule was working ok, morning rule never worked. I have noticed that morning rule was set to turn on the "dimmer" to 100 %, while when I did closing via app it was showing dimmer status at 99%. Changed the morning rule to turn on and dim to 99% and now everything works fine. So, everything works now, and I can wait while Securifi team adds full fibaro sensors support to A+.
-
IOS support is not just there yet. It might take some time till support for multi function sensor gets added. Thanks for the heads up though.
-
What about Android? Will it work there? I've been waiting for Fibaro rolling shutter support to buy me some.
-
For this device type, the very next Android release would have support. IOS will still take some time. So if you are an Android user, you may wait for the next Android app update before you get your hands on one of them.
-
Couldn't wait, ordered one ;D
Works great with the LCD, unfortunately not supported anywhere else yet.
I would have hoped I could already use it in a rule, but no such luck, the device isn't listed.
-
Couldn't wait, ordered one ;D
Works great with the LCD, unfortunately not supported anywhere else yet.
I would have hoped I could already use it in a rule, but no such luck, the device isn't listed.
as I already mentioned, just reconnect it not as roller shutter but as multiswitch (A+ will ask you what is the sensor during pairing) and then it will be supported in ios or android app.
-
Yes, I saw, but I've decided to wait until it is fully supported as intended. Otherwise I'll have to unpair/pair it again later. :)
[edit]
Did it anyway, seems to be working OK. Made some rules for morning/evening, we'll see if those work too :)
-
Any change with the R075-firmware? Or should I wait a little longer before removing and pairing again? :)
-
So, how about support in R076?
-
Hello,
I am following up, regarding the the FIBARO blind controller. Can you confirm that FIBEFGR-223 3 Roller Shutter 230 V, can be controlled by Almond+ iOS app?
I am about to buy it.
Thanks!