Securifi Community Forum
Sensors and Home Automation => Home automation => Topic started by: geraldl on August 07, 2015, 11:03:58 am
-
I have read that support for the PSE02-2 was added to firmware. I just bought a EU version of the PSE02 but I notices that it is a PSE02-1B.EU version. I can pair the z-wave device but it will not listen to the GUI commands of the almond+ (no , the command of the iOS app or the commands sent by the webbrowser. I removed the device several times and added it again. But it will not work.
Once when I pushed the bell signal the PSE02 reacted after 10 seconds and it made a lot off noise. But I could not stop it. I put it under a pillow and waited until it stopped. Could you please add support of the PSE02-1B version?
Gerald