Securifi Community Forum

Securifi Products => Almond+ => Topic started by: Paholainen on November 23, 2015, 05:07:15 am

Title: "invalid time selected"
Post by: Paholainen on November 23, 2015, 05:07:15 am
Get the error "invalid time selected" when creating a rule for a on/off switch when a motion sensor triggers between selected times. It still kind of works. First time it worked ok for about 12 hrs, then started turning on/off lamp at random with only a few seconds interval. Reset the rule and it worked for about 3-4 days, and now it started turning on the lamp any time it sense motion, even outside the timeframe I set for it. The lamp is set to be on for 180 seconds.
Title: Re: "invalid time selected"
Post by: Ashok on November 23, 2015, 07:27:10 am
@ Paholainen,

It would be helpful, if you could let us know which Motion sensor you are using and also send us logs (Help->Send Logs), so that we can debug and get back to you. Thank you!
Title: Re: "invalid time selected"
Post by: Paholainen on November 23, 2015, 10:34:22 am
Fibaro multi sensor and fibaro wall plug. Will try and send logs later
Title: Re: "invalid time selected"
Post by: Ashok on November 23, 2015, 11:46:14 am
Thank you for providing the info and ensure that the Almond+ is not rebooted before sending the logs.
Title: Re: "invalid time selected"
Post by: Paholainen on November 24, 2015, 04:21:29 am
Sent the logs today. "invalid time selected. fibaro"
Title: Re: "invalid time selected"
Post by: rldreams on November 24, 2015, 10:20:01 am
This is a LONG standing issue. Times CAN NOT cross midnight . So you need to make 2 rules. Rule one  5PM until 11:59 PM and a second rule 12am until 6am . Or whatever your on, off times for the rule should be.
Title: Re: "invalid time selected"
Post by: Paholainen on November 24, 2015, 10:27:18 am
Ok cool. Did not know that.