Securifi Community Forum
Sensors and Home Automation => Home automation => Topic started by: freddanster on September 10, 2014, 02:51:39 am
-
Hello!
I'm new to this whole Z-wave thing, and i believe i'm just having this problem because this sensor isn't supported yet.
I've added the ZXT-120 (it's an AC IR extender) to my Almond+.
Everything shows up fine in the interface, only the current temp is in celcius (which i want) while the setting sliders for heat/cooling are in fahrenheit, but that's not my issue hehe.
The manual of the thing says to do this to learn my unit the IR codes from my AC remote:
"Go to configuration setting page on
the gateway [...] and input
parameter number “27” and
parameter value “000” to select the
dedicated AC code number “000”
for learning".
I see nowhere where to send parameter values to my unit from the web ui.
As i said i believe it's simply because this sensor is not supported yet, but i want to ask if im missing something obvious since i'm a novice.
Regards,
Fredrik