Securifi Community Forum
Sensors and Home Automation => Home automation => Topic started by: LeaChim on November 13, 2014, 04:45:19 pm
-
Is there any way to set parameters, even if it's from the console?
I've got some fibaro dimmers that only partially work with my lights, until I can change some of the parameters to make them work properly.
-
Not at the moment I'm afraid. It's something I've been pushing for, but it'll require a fair bit of work on our side.
-
Is there not even a way from within a shell?
-
Not at the moment, no, not that I'm aware of.