Securifi Community Forum

Sensors and Home Automation => Home automation => Topic started by: Simonups on August 02, 2014, 02:24:28 pm

Title: Z-Wave USNAP module for Thermostat
Post by: Simonups on August 02, 2014, 02:24:28 pm

Tested the Z-Wave USNAP module for 3M-50 thermostat and does link with almond+.
Change the setting is instead.

Current have the wifi and z-wave connected to the thermostat and both can control the settings.

You can control the temp but does not update the current temp inside the house. The sliders need to have a value instead a dot or triangle where you see what temp is been set.
The web interface "https://connect.securifi.com/home" or login to router with the IP address and the Display of the router does not update the current temp.
Almond+ , web and display shows 77 degree, but thermostat show 73 degree.

Title: Re: Z-Wave USNAP module for Thermostat
Post by: Simonups on March 23, 2015, 11:13:34 am

bump

Title: Re: Z-Wave USNAP module for Thermostat
Post by: LGNilsson on March 23, 2015, 10:23:36 pm

Is this the RadioThermostat module? As it's the only one we support so far.

Title: Re: Z-Wave USNAP module for Thermostat
Post by: Simonups on March 24, 2015, 09:21:20 pm

This is a CT50 from Radio Thermostat. I have a Wifi module installed and z-wave module. Wifi works perfect.
The Almond+ will see the readings when you sync to it like add the sensor. Will work for max 10 min then will not work anymore,
You cant change afterwards the settings for the thermostat and will not it show changes when you apply direct on the Thermostat.
Can it be the almond loses it connection on the Thermostat?
How often does it send a life signal to the sensor.