Securifi Community Forum

Securifi Products => Almond+ => Topic started by: brycied00d on August 15, 2014, 12:01:46 am

Title: Post-upgrade Stuck in LCD Calibration
Post by: brycied00d on August 15, 2014, 12:01:46 am

The upgrade to R65 seemed to go well. I opted to keep my settings. Following the upgrade, I was prompted to perform the "Factory Test for Touch Screen" as expected. I complete the test and I was left with:
(http://i.imgur.com/YLYcaBdl.jpg)`
(Note: 2.4GHz is disabled). The device continued to function normally otherwise: web UI, WiFI, making changes (yay AP/bridge mode) etc; only the LCD is non-responsive. After about 20 minutes, I rebooted the router (via connect.securify.com). Upon reboot, I was prompted with the "Factory Test for Touch Screen" once again. I repeated this twice more.
Finally I decided to do a hard reset, it rebooted, I performed the test once more and finally then was greeted with the standard startup wizard.

So I'm back up and running, but I'm reporting this as a bug all the same.

Title: Re: Post-upgrade Stuck in LCD Calibration
Post by: brycied00d on August 15, 2014, 12:07:39 am

PS: Note the spelling error in "setTelent" (as opposed to "setTelnet")

Title: Re: Post-upgrade Stuck in LCD Calibration
Post by: LGNilsson on August 15, 2014, 12:41:05 am

This issue happened because your 2.4GHz radio was disabled and the hard reset fixed that issue.
Thanks for the heads up though.

Title: Re: Post-upgrade Stuck in LCD Calibration
Post by: sorphin on August 15, 2014, 02:15:56 am

Interesting.. I've not had this test at any point before or after the upgrade.

Quote from: brycied00d on August 15, 2014, 12:01:46 am

The upgrade to R65 seemed to go well. I opted to keep my settings. Following the upgrade, I was prompted to perform the "Factory Test for Touch Screen" as expected. I complete the test and I was left with:
(http://i.imgur.com/YLYcaBdl.jpg)`
(Note: 2.4GHz is disabled). The device continued to function normally otherwise: web UI, WiFI, making changes (yay AP/bridge mode) etc; only the LCD is non-responsive. After about 20 minutes, I rebooted the router (via connect.securify.com). Upon reboot, I was prompted with the "Factory Test for Touch Screen" once again. I repeated this twice more.
Finally I decided to do a hard reset, it rebooted, I performed the test once more and finally then was greeted with the standard startup wizard.

So I'm back up and running, but I'm reporting this as a bug all the same.

Title: Re: Post-upgrade Stuck in LCD Calibration
Post by: LGNilsson on August 15, 2014, 02:18:43 am

This issue would only affect the first 1k, as they shipped with a different firmware.

Title: Re: Post-upgrade Stuck in LCD Calibration
Post by: sorphin on August 15, 2014, 02:28:05 am

Quote from: Lars on August 15, 2014, 02:18:43 am

This issue would only affect the first 1k, as they shipped with a different firmware.

10-4