Securifi Community Forum

Securifi Products => Almond+ => Topic started by: Kazy on August 18, 2014, 03:37:19 pm

Title: Hard Drive Space remaining in Windows?
Post by: Kazy on August 18, 2014, 03:37:19 pm

Hello!

I just got my Almond+ today, and hooked up a 4TB USB hard drive to it.  The hard drive is formatted to NTFS, and I want to map it to a network drive in Windows.  I've been able to do this, but it just shows a red bar where it usually shows how much space is available. Anyway to make it so I can see how much space is remaining in Windows?  I'm using Samba.

Thanks!

Title: Re: Hard Drive Space remaining in Windows?
Post by: LGNilsson on August 19, 2014, 03:06:40 am

I'm honestly not sure if the version of Samba we're currently using supports 4TB drives.
We're working on getting this updated though, but it'll most likely take a month or two before that'll be out in a new firmware.
I'm assuming you're on firmware R065, as we did have some issues with this on the older firmwares.

Title: Re: Hard Drive Space remaining in Windows?
Post by: robh5791 on August 19, 2014, 10:13:09 am

I had a smaller USB drive plugged into and mapped through the Almond+ and it shows the same red bar on my windows laptop. I am able to read and write but the space used and available does not show. I think it was a 16 gb USB drive and it definitely shows the space when plugged directly into a USB port.