Securifi Community Forum

Securifi Products => Almond+ => Topic started by: cavemanghost on September 04, 2014, 01:23:58 pm

Title: UPnP, NAT-PMP, and Port Forwarding not working
Post by: cavemanghost on September 04, 2014, 01:23:58 pm

I cannot for the life of me figure out what I'm doing wrong. I'm trying to forward ports for Transmission OSX and I have tried setting up a manual forward rule and have also gone into OpenWRT and enabled UPnP and NAT-PMP, which Transmission supports. Even using any of these options (or a combination), I just can't open up any ports. Suggestions?

Title: Re: UPnP, NAT-PMP, and Port Forwarding not working
Post by: pseudorandumb on August 26, 2015, 10:32:43 pm

Apparently port forwarding is turned off by default inside the OpenWRT settings under firewall. Try turning that on.